This video will show you how to diagnose the ABS , AIRBAG , SRS, or AIR BAG light on your Honda and or Acura cars.

Should  work on:

Acura cars

Acura TL

Acura TSX

Acura RSX

Acura MDX

Acura RDX

Acura RL

Honda cars:

Honda Accord

Honda Civic

Honda Pilot

Honda FIT

Honda Element

Honda CRV

Honda Odyssey

Honda Insight

Honda S2000

Diagnose instructions.

1 Find the OBD connector ( on board diagnostic connector ) located on the left side under the dash.

2 Find the number 4 and number 9 pins you can read it on the plug .

3 Pin number 9 is a brown wire and pin 4 is a black wire  make sure you have the right pins and wire colors or you will burn a fuse or short something in the car.

4 Get a paper clip and jump the #4 and #9 pins together .

5 Turn on the ignition and the Airbag , ABS , engine lights will blink .

6 Count the blinks .

7 Example if the light blinks slow 5 times and fast 1 time its code 51. (as seen in video )

8 Go to www.vehix411.com on main page you will find trouble codes definitions link or search the code in our search box.

9 That’s how you diagnose an airbag , abs , engine light on Honda and Acura cars . 

This video will show you how to fix or repair the speedometer on 1996 , 1997 , 1998 , 1999 , 2000 Subaru Legacy Outback . If your car is not showing the millage of how fast you are going or sometimes works and sometimes doesn’t.

Remove your speedometer flip it to the back side you will see a blue connector housing , get a small screw.  Screw it in the corner of the gap between the connector and circuit board housing as seen in the video , by the way in the video i said your other choice is to repair i meant replace the speedometer my mistake lol ok   make shore its not touching the circuit board or you will fry your speedometer. Install the speedometer and test drive the car.

Watch a part 1 on how to test or diagnose if your speedometer is bad.

This video will show you how to reset your oil light, service reset , spark plug reset, radiator coolant reset, brake pad reset on all 2006, 2007, 2008, and 2009 3 series BMW . ( click on topic to leave a comment thank you )
ANNOUNCEMENT GOVERNMENT AUTO AUCTION      Click Here!    ANNOUNCEMENT

This video will show you how to reset your service interval for, front  brake pad light, rear brake pad light, brake fluid service, spark plug service, coolant service , and oil service interval .  2004, 2005, 2006, 2007, 2008, 2009  BMW  5 SERIES 525, 530, and 540  .

Reset Instructions:

1 Ignition on ( don’t start the car )

2 Go to your turn signal switch and find the check button.

3 Push the check button and look in the instrument penal display until you see the date or clock.

4 Push and hold the reset button on the left side of the instrument panel until the display shows the failed service or service due.

5 Let go of the reset button on the instrument penal.

6 Within 5 sec push the same reset button on the instrument panel and keep on pushing until you see the  service , front  brake pad light, rear brake pad light, brake fluid service, spark plug service, coolant service , and oil service interval  reset . The service thet  is past due will be in red the other thet are in orange and yellow are not due yet.

7  By pushing the reset button you will find the service needed to reset hit the reset button in thet window and hold it.

8 When  the display reads RESET  on the bottom window you let go of the reset button and push it again and hold it until It displays lines and 15000 or what ever service schedule is required for thet service and thet display will turn into orange color.

9 Just turn off the ignition and that’s how you reset your service on BMW 5 SERIES.

Tools needed for the job : Paper clip

Parts needed for the job : watch the video and the car will give you the code see trouble codes on our site and you will know  what parts are needed                                                                                 Performance Products® – Low Prices on Truck/SUV parts.